Totech is the world’s first and largest manufacturer of electronic dry cabinets/ Super dry cabinet/ dry box/ desiccant dry cabinet/ IC storage cabinet/ PCB storage cabinet/ Nitrogen cabinet/ drying cabinet/baking cabinet/ low humidity cabinet/electronic dry cabinet/dehumidifier/ dehumidifying cabinet/ LED storage cabinet/camera dry cabinet/ lab dry cabinet.
Baking is needed to reset the floor life of MSDs, to deal with MSDs that the exposure time has exceeded the floor life in the ambient environment or even the MSDs that expose in the environment for only a short time. Backing can extend the storage time and ensure the quality safety. However, with the development of new style of chip encapsulation and mounting technics, the traditional high temperature backing shows its shortcomings.
Problems Caused by Traditional High Temperature Baking
Some MSD reels and racks are not suitable for high temperature baking, and the efficiency would be very low if baking after taking off the MSDs from the racks.
Some MSD components and PCBs can not bear high temperature baking for a long time.
For some other MSD components, if the temperature is higher, the damage caused to
the components would be more serious, even though the components can bear the
high temperature, there would still be potential thermal destruction and oxidation, or
there would be inter metallic growth at the inner joint of the components, reducing
solder ability.
Baking is only possible one time according to IPC, and the components must be processed
at once after baking to avoid re-absorption of moisture.
With the popularity of IPC/JEDEC J-STD-033D, people are taking more consideration on the the double functions of dry cabinets with ultra-low humidity and medium temperature baking. Our Super Dry medium temperature baking cabinets MSD Series install a 60℃ (Set from room temperature to 60℃ ) heater into our dry cabinets to acceralate the dehumidification. And if the MSD Series are used in all production processes, not only the defective products caused by thermal stress can be avoided, but also the process can be simplified and the production cost be reduced.
