Socket Screw Extractor Set DBZ-20 ENGINEER

Extractor bit set for damaged screws including but not confined to hex socket and Phillips heads!

Works with 2~5mm (Across Flats) stripped hex socket of cap bolt, countersunk or button head
Used manually with 6.35 driver handle or with a power screwdriver
Sharp & fine-pitch spiral tip grips a hex socket without slippage.
Also useful as an extractor for other screw drives such as Phillips, Torx, etc. if an electric drill is used to make a pilot hole (The process described below.)
Bit size : 105mm x Hex. 6.35mm
Material : High carbon steel

Add to quote

SKU DBZ-20 Category Nut/Screwdrivers & Hex

Application to Socket Screws

1- Press the extractor bit into the stripped socket.
2-Twist it out while keeping the bit pressed firmly. When using a power screwdriver, select slower speed in reverse mode and spin it counterclockwise.

Application to Phillips & other drives

1- Drill a pilot hole in the center of screw head.
2- Select the appropriate size of DBZ-62/63/64/65 (2mm, 3mm, 4mm or 5mm), which corresponds to the pilot hole (the diameter of the drill used).
3- Apply a tip of the extractor and spin it counterclockwise while pressing downward. A power screwdriver can be also used. (slower speed recommended)